The M-SST-58-12 SmartTable HD Series uniquely combines the powerful IQ® active damping technology with passive precision tuned damping technology used in RS series tables. The two technologies compliment each other, creating the highest performance table in the industry. The included ST-300 SmartTable Controller can be used in a stand-alone (no computer required) mode and is also USB2 compatible. When operating in the stand-alone mode SmartTable HD automatically tunes the table to maximize table damping independent of load. When connected to a computer via the USB2 port, the included software allows users to further fine tune and calibrate the table to the experiment at hand and gather vibration data in both the frequency and time domains. Isolators are sold separately.
宽度
1500 mm
长度
2400 mm
厚度
305 mm
安装孔
M6
表面平面度
± 0.1 mm over 600 mm square
带宽
monitoring vibration: 10-820 Hz and structural damping: 80-550 Hz
宽带阻尼
Constrained layer core, damped working surface and composite edge finish
调谐阻尼
IQ active and 2 precision tuned dampers
安装孔分布
25 mm grid
安装孔边距
12.5 mm
工作表面
400 series ferromagnetic stainless steel
顶部和底部表层
3/16 in. thick with integrated damping layer
纤芯设计
Trussed Honeycomb, Vertically Bonded Closed Cell Construction, 0.010 in. Steel sheet materials, 0.030 in. triple core interface
密封孔类型
Easy clean conical cup, 19 mm deep, non-corrosive high impact reinforced composite material
计算机接口
USB
电源要求
100-240 VAC; 1.5A, 50/60Hz
的M-SST-58-12 SmartTable HD系列独特的结合了强大的智商®主动阻尼技术与被动精密调谐阻尼技术用于RS系列表。这两种技术相辅相成,创造了业界最高的性能表。所包含的ST-300 SmartTable控制器可以在独立(不需要计算机)模式下使用,并且与USB2兼容。在独立模式下运行时,SmartTable HD自动调优表,最大限度地减少表的阻尼,不受负载影响。当通过USB2端口连接到计算机时,所包含的软件允许用户进一步微调和校准表以进行手头的实验,并收集频率和时域的振动数据。隔离器是分开出售的。