The 2034 Infrared Optical Receiver operates out to 2.2 μm for IR laser or signal detection. With a compact housing and an adjustable gain setting, this photoreceiver is easy to use. The three-setting gain adjustment allows you to keep your signal from going off scale while you’re adjusting your experiment or measurement. These photoreceivers are battery powered so you’ll need only a single coaxial cable to connect the photodetector to other instruments. To ensure long battery life, we build these photoreceivers using amplifers with low-current draws. If you’re unsure about the battery status, the built-in battery check can tell you instantly whether or not the battery is good. The compact housing lets you slide the photoreceiver in wherever you need to quickly check your signal. Since all switches and connectors are located on the top of the housing, you won’t have to worry about access or about cables that drag on the table and block your beam. For mounting it has a 8-32 mounting thread and we include an. M4 metric adaptor and tool.
探测器直径
1.0 mm
3 dB 带宽
700 kHz, 90 kHz, 80 kHz
波长范围
800-2200 nm
探测器材料
InGaAs
探测器类型
PIN
最大转换增益
2.2x106 V/W
最大跨阻抗增益
2x103, 105, & 2x106V/A
NEP
43 pW/√Hz
饱和功率
2.3 mW
峰值响应度
1.1 A/W
最大功率密度
5 mW/mm2
输出接头
BNC
输出阻抗
100 Ω
螺纹类型
8-32 (M4 thread adapter included)
2034红外线光接收机操作2.2μm红外激光或信号检测。具有紧凑的外壳和可调增益设置,这种光电接收器易于使用。三设置增益调整,让您保持您的信号不偏离规模,而您正在调整您的实验或测量。这些光电接收器是电池供电的,所以你只需要一根同轴电缆就能把光电探测器和其他仪器连接起来。为了保证长时间的电池寿命,我们使用低电流的放大器来制作这些光电接收器。如果你不确定电池的状态,内置的电池检查可以立即告诉你电池是否好。紧凑的外壳可以让你在任何需要快速检查信号的地方滑动光电接收器。由于所有的开关和连接器都位于外壳的顶部,所以您不必担心接入或电缆拖到桌子上并阻塞您的波束。对于安装它有一个8-32安装线程,我们包括一个。M4公制适配器和工具。