The CC-595S TE Controller/Laser Diode Mount Interconnect Cable is designed to interface between ILX Lightwave's LDT-5940C and LDT-5900 series Precision Temperature Controllers and Laser Diode Mounting Fixtures. Twisted pair signal wires and braided shielding help minimize noise generation and reception by the cable, which means less noise in the lasers output. The cable is terminated on one end with a 25-pin male D-sub connector for easy connection to the temperature controller. The opposite end is terminated with a 9-pin female D-sub connector to allow attachment to any standard ILX Lightwave laser diode mounting fixture. Four-wire measurement of TEC voltage is possible with this cable.

• 类型

  TEC Controller to Mount Cable

• 最大电流

  5A  

• 端口类型

  DB25 Male to DB9 Female

• 长度

  6ft (1.8m)

• 数量

  1

• 
  

CC-595S TE控制器/激光二极管安装互连电缆设计用于ILX Lightwave公司的LDT-5940C和LDT-5900系列精密温度控制器及激光二极管安装夹具之间的接口。双绞线和编织屏蔽有助于减少由电缆产生的噪声和接收，这意味着激光输出的噪声更少。电缆一端用25引脚的插头D-sub连接器端头，便于与温度控制器连接。另一端端接一个9引脚的D-sub连接器，允许连接到任何标准的ILX光波激光二极管安装夹具。四线测量TEC电压是可能的与此电缆。