The FSR-OD50 Absorptive Neutral Density Filter is a 1 inch (25.4 mm) diameter absorptive neutral density filter that has an Optical Density of 0.5 at 546.1 nm, and provides broadband attenuation for the visible to near-infrared region. This filter is precision polished for demanding research or OEM applications. The filter's Optical Density is permanently marked on the filter and is shipped with a transmission curve. Our unique assortment of filters permits easy selection of any desired density from 0 to 8 with 0.1 OD resolution by using individual filters or a combination of no more than two filters. The total filter set range is 0 to 8 OD. Optical density (OD) is defined by the relationship: OD = -log(T) or T = 10-OD, where T is transmission (0=T=1). The density of a series of filters, unlike transmission, is additive. Custom densities can therefore be obtained by stacking filters, however stacking an excessive number of filters can lead to numerous unwanted back reflections. Due to the absorptive nature of the filter glass, use with high power lasers should be avoided. Power levels less than 30 W/cm2 are advised.

• 尺寸

  Ø25.4 mm

• 光学密度

  0.5

• 光学密度公差

  ±4% at 546.1 nm

• 波长范围

  400-900 nm

• 入射角

  0°

• 楔形

  ≤3 arc min

• 透射

  31.6 % at 546.1 nm

• 尺寸公差

  ±0.3 mm

• 表面平面度

  ≤2λ at 632.8 nm over the clear aperture

• 表面质量

  60-40 scratch-dig

• 倒角

  0.25–0.76 mm face width

• 倒角公差

  45° ±15°

• 清洁

  See How to Clean Optics

• 通光孔径

  ≥central 80% of dimensions

• 损伤阈值

  30 W/cm2 CW, typical

• 厚度

  0.99-4.19 mm

• 厚度公差

  ±0.1 mm

FSR-OD50吸收中性密度滤光片为直径1英寸(25.4 mm)的吸收中性密度滤光片，其光密度为0.5，在546.1 nm处，为可见光到近红外区域提供宽带衰减。该过滤器是精密抛光的要求研究或OEM应用。滤光片的光密度永久地标记在滤光片上，并随传输曲线一起传送。我们独特的过滤器种类允许使用单个过滤器或不超过两个过滤器的组合，以方便地选择任何所需的密度从0到8和0.1 OD分辨率。总的过滤集范围是0到8 OD。光密度(OD)定义为:OD = -log(T)或T= 10-OD，其中T为传输(0=T=1)。与传输不同的是，一系列过滤器的密度是附加的。因此，可以通过叠加滤波器获得自定义密度，但是叠加过多的滤波器会导致许多不必要的反射。由于过滤玻璃的吸收特性，应避免与大功率激光器一起使用。建议功率级别小于30 W/cm2。