The PSM2SG Piezo Steering Mirror Mount with Strain Gauge provides high-speed, sub-microradian resolution, tip, tilt, and z motion for mirrors, gratings and other optics. Equipped with a direct piezo actuation system without lever arm transmission, the PSM2SG is ideally suited for high bandwidth laser beam steering, switching and stabilization, beam scanning, image stabilization, and laser cavity tuning. Fast and reliable motion is supplied by three multi-layer, low-voltage piezo stacks (PZT) in a right triangle configuration. The length of each piezo stack can be controlled individually. Applying a voltage to one stack, results in a tip or tilt. Changing the length of all three stacks simultaneously, results in a linear z-displacement. The tip and tilt are othogonal, with no need for coordinate transformations as required with alternative designs where the piezo stacks are placed in 120 ° intervals. The parallel motion design of the PSM2SG has also the advantage of being fully temperature compensated, i.e. changes in the environmental temperature do not affect the tilting angle. PSM2SG units are also maintenance-free and are not subject to wear. The PSM2SG provides absolute position control, high linearity, and high repeatability based on internal strain-gauge position sensors. The position feedback compensates also for actuator creep. For highest position stability and highest temperature insensitive performance, the sensors are built in a full Wheatstone bridge design. The PSM2SG can be operated in either open or closed-loop control.Use with the XPS-C4 controller and three XPS-DRVP1 driver cards.


PSM2SG压电转向镜安装有应变计，提供高速，亚微米分辨率，尖端，倾斜，和z运动的镜子，光栅和其他光学。PSM2SG具有不需要杠杆臂传输的直接压电驱动系统，非常适合用于高带宽激光束转向、开关和稳定、光束扫描、图像稳定和激光腔调谐。快速和可靠的运动是由三个多层，低压压电堆(PZT)在一个直角三角形配置。每个压电堆的长度可以单独控制。对一个堆叠施加电压，会导致顶部或倾斜。同时改变三个堆栈的长度，会产生一个线性z位移。提示和倾斜othogonal,根据需要不需要坐标转换与替代设计压电堆在哪里放置在120°的间隔。PSM2SG并联运动设计还具有温度补偿充分的优点，即环境温度的变化不影响倾斜角度。PSM2SG机组也是免维护的，不受磨损。PSM2SG基于内部应变片位置传感器，提供绝对位置控制、高线性度和高重复性。位置反馈还可以补偿执行机构的蠕变。为了获得最高的位置稳定性和最高的温度不敏感性能，传感器采用了完整的惠斯通桥设计。PSM2SG可以在开环或闭环控制下运行。与XPS-C4控制器和三个XPS-DRVP1驱动卡一起使用。