The SMC100PP is a single axis motion controller/driver for 2-phase stepper motors up to 48 VDC at 1.1A peak per phase. It is a compact and low-cost controller for most of Newport’s stages, like the UTS and ILS linear stages, URS rotation stages, and TRA actuators. Communication with the SMC100 is via the integrated RS-232-C interface, or a USB port using the SMC-USB adapter. Advanced application programming is simplified by an ASCII command interface and a set of two-letter mnemonic commands. When used with Newport ESP stages, the SMC100 will automatically detect the connected stage for the safest and easiest system configuration. This exclusive Newport feature does not only reduce configuration time, but is also the best protection of your equipment from any accidental damage. Up to 31 controllers can be networked through the internal RS-485 communication link. This internal multi-drop full-duplex serial link simplifies communication to several units, without the need for sending address selection commands. This results in enhanced multi-axes management with improved program readability and faster communication compared to alternative systems based on an RS-232-C chain. The SMC100 also features advanced multi-axes commands, such as Stop all or Start a motion of all axes and performs at a 57,600 baud rate communication speed. Furthermore, for an efficient process control, the SMC100 features dedicated digital outputs for In Motion and Not referenced.The SMC100PP comes with a power and network cable for daisy chaining when stacked.

For stage compatibility click here: Stage Compatibility Matrix

MC100PP是一种单轴运动控制器/驱动器，适用于2相步进电机，最高可达48 VDC，峰值为每相1.1A。它是一个紧凑和低成本的控制器的大多数新港的阶段，如UTS和ILS线性阶段，URS旋转阶段，和传动器。与SMC100的通信是通过集成RS-232-C接口，或使用SMC-USB适配器的USB端口。高级应用程序编程通过ASCII命令接口和一组两个字母的助记符命令来简化。当与Newport ESP阶段一起使用时，SMC100将自动检测连接的阶段，以获得最安全和最简单的系统配置。这个独有的新港功能不仅可以减少配置时间，而且是您的设备免受任何意外损坏的最佳保护。多达31个控制器可以通过内部RS-485通信链路联网。这种内部的多点全双工串行链路简化了通信到几个单位，不需要发送地址选择命令。与基于RS-232-C链路的替代系统相比，这种方法增强了多轴管理，提高了程序的可读性和更快的通信速度。SMC100还具有高级的多轴命令，例如停止所有轴或启动所有轴的运动，并以57,600波特率通信速度执行。此外，为了有效的过程控制，SMC100具有专门的数字输出的运动，而不是参考。SMC100PP附带一个电源和网络电缆，用于菊花链时，堆叠。

关于舞台兼容性，请点击这里:舞台兼容性矩阵